HS2 - Westgate Sump Pumps(Sub-subcontract Package)

Description

To install a complete and compliant Public Health installation to the project specifications including (but not limited to) the following: • Design, Supply and installation of the two pump sets at Westgate, the Sump Pump (FSP-01) and Retention Tank Pump Set (RTP-01) • All pipework inside the sump and up to the header including all valves on the header, as shown in demarcation sketch. • 3D drawings to be produced for the inclusion in Phoenix BIM Model showing all devices and guide rails. • All pump guides inside sump or retention tank • Control panels for pumps • Control devices, both analogue and digital. • Commissioning of pumps with a full FAT and SAT • Wiring of control devices between device and control panel • All pumped drainage pipework shown on the 2D drawings from the pump to the header. • All support systems and fixings required to support the pipework in the sump and tank areas • All support systems and fixings required to support the pipework. Supports shall be installed to correct spacings or less, as determined by the pipework calculations. • All Unistrut, drops rods and other materials required to construct brackets and supports are required to be installed to the approved MCR. • Installation check sheets shall be completed by the sub-subcontractor. • Demonstration to Phoenix and client on how the pumps are removed for maintenance.